Control

1. Shutdown Now: This command will execute the shutdown procedure at once. 
 
a. Restart: This function lets you restart the OS and UPS automatically 
		after being shutdown. To start the OS and UPS for next schedule, 
		mark the Restart check box. 
b. Shutdown OS and UPS: Use this function to shutdown both OS and UPS. 
c. Shutdown OS Only: Use this function to shutdown OS only. 
d. Suspend OS Only: Use this function to suspend your operating system. 


2. Cancel Shutdown: This menu enables you to terminate the current 
		shutdown procedure. 


3. Turn Receptacle Relay On: Turn the selected receptacle relay on. 
		Each Receptacle Relay may control not only one outlet, 
		please see the rear panel of your UPS or the UPS hardware 
		user's manual. 
 
a. Select a Receptacle Relay: Select a receptacle relay. 
b. Delay: Set the delay time to turn on the receptacle relay. 
c. On: Execute the turn on command.

 
4. Turn Receptacle Relay Off: Turn the receptacle relay off. Each 
		Receptacle Relay may control not only one outlet, please 
		see the rear panel of your UPS or the UPS hardware user's 
		manual. 
 
a. Select a Receptacle Relay: Select a receptacle relay. 
b. Delay: Set the delay time to turn off the outlet group. 
c. Off: Execute the turn off command. 


5. UPS Audible Alarm On: Enable UPS buzzer. At the Bottom Layer 
		Buttons press the Status button to get the UPS buzzer status. 


6. UPS Audible Alarm Off: Mute UPS buzzer alarm. 


7. 10 Seconds Test: UPS switch to backup mode and output power 
		supplied by battery in 10 seconds. 


8. Deep Battery Test: UPS switch to backup mode and output power 
		supplied by battery until battery low. 
		
		
9. Cancel Test: This menu allows you to stop testing of UPS immediately.